2006 2007 2008 2009 2010 2011 Honda Civic 1.8L Reman AC A/C Compressor

Description

The picture listed on this page is a representation of the compressor you will be receiving.
Every compressor meets and or exceeds OEM specifications. Every compressor is leak tested and function tested to make sure every compressor that is shipped to you, the customer, is a high quality re-manufactured a/c compressor. We offer a 1 year, 12 thousand mile warranty from the date of purchase. Every reman compressor has a new control valve installed!
I
f you are not 100% sure that this compressor is yours please feel free to message us and we will verify fitment application.
We also offer pag oils and other related automotive a/c parts. We can be your one stop parts store for your auto a/c replacement part needs. Just message us with your year,make, model, engine size, and we will supply you with the parts you desire.
EVERY COMPRESSOR COMES WITH ONLY TESTING OIL. EVERY COMPRESSOR NEEDS TO BE DRAINED OF TESTING FLUID AND NEEDS THE ESTIMATED AMOUNT BASED OFF OF OEM SPECIFICATIONS  WHICH CAN BE FOUND IN ANY REPAIR MANUAL, ALLDATA, OR MITCHELL ON DEMAND WEBSITES.
In most cases you will have to reuse your oem manifolds and switches from your original compressor. The reasoning is 1 compressor can fit numerous vehicles and not one manifold and or switch fits all vehicles.
In most cases the connector/plug from the original compressor will need to be spliced on to our
compressor. Every compressor that needs this done will come with 14-16 gauge heat shrink butt splices.
This 1 year 12,000 mile warranty is good for a 1 time replacement compressor.
In order to receive a warranty compressor the following parts and procedure must have been replaced.
1.The accumulator/drier MUST be replaced any time the a/c system has been opened. If this part has not been replaced upon compressor replacement warranty is void.
2.If the system was a catastrophic failure. Accumulator/drier, orifice tube and or expansion device, and condenser MUST be replaced as well as a complete system flush. If these step have not been done regarding a catastrophic compressor failure, warranty is void.
There will be a warranty questionnaire that will need to be thoroughly answered to attain the warranty compressor
Ships to all 50 states, U.S. Territories, Canada, and Worldwide.
Disclaimer: We will not pay any labor claims.
Not all items will ship from the advertised location due to having multiple warehouses around the United States!
Document
NOTE: Each AC air compressor comes with about 100ML of Oil. You dont need to add oil additionally.
Take appropriate safety precautions
1. Wear eye protection (safety glasses).
2. Do not smoke next to the vehicle when performing repairs.
3. Work in a well-ventilated area.
4. Wear skin protection (such as gloves and closed toe shoes).
5. Recover refrigerant before making repairs.
Installation Method
Attention Please:
Be sure to clean the air conditioning system before installation, otherwise it will cause compression broken.
1.
Remove compressor:
Remove the A/C belt from the A/C compressor pulley. May involve loosening the belt tensioner (if equipped).
2.receiver drier or accumulator, orifice tube or expansion valve.
3.Disconnect the negative battery cable.
4.Remove the bolt that secures refrigerant lines to the A/C compressor. Inspect A/C lines for any contamination such as metal or excessive dirt inside of them. If you find any contamination the system will need to be cleaned.Flush the condenser and evaporator using NON-OIL BASED A/C flush. On expansion valve systems. The valve must be removed before the  evaporator can be flushed. Flushed condensers from outlet to inlet and evaporators from inlet to outlet.
5.Drain all the oil from the new compressor ,if you compressor has a drain plug you will need to open it up and drain what oil is in there too.
6.Install half oil charge into the compressor and the remainder throughout the system. Turn compressor shaft 8-10 full revolutions to insure front seal and other internal parts are lubricated.
7.Install new receiver drier or accumulator and new orifice tube or expansion valve.
8.Evacuate the A/C system for a minimum of one hour.
9.After evacuation install half the refrigerant charge and let the system set for 1 minute. This will allow the refrigerant to pick up oil and spread more evenly throughout the system.
10.Turn on the A/C system with the engine running and check to see if cold air is now coming out of the air duct.
11.If the A/C system is functioning ,you may find that your electric radiator fan and compressor clutch will be cycling off and on depending on the outside air temperature
NOTE
T
o confirm that this part fits your vehicle, enter your vehicle's Year, Make, Model, Trim and Engine in the
Compatibility Table
.
Please make sure the plug is the same as your old one
Please add 70-80% refrigerant, do not need to fill up
Noise is generated if too much refrigerant is added
Package Included:
1pc A/C Compressor
（Professional Installer is Highly Recommended ）
WE ACCEPT THESE PAYMENT METHODS
( 10% sales tax will be applied for orders shipped to Washington state by state law )
30 Days easy returns satisfaction guarantee.
Items to be returned must be in original factory condition.
Please enclose a note about item number and order id, your eBay ID and the reason of return.